現場組裝式光纖活動連接器檢測

現場組裝式光纖活動連接器檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

GB 50673-2011有色金屬冶煉廠電力設計規范

本規范適用于有色金屬冶煉廠新建、改建和擴建工程的電力設計。

GB 51204-2016建筑電氣工程電磁兼容技術規范

本規范適用于新建、擴建和改建的民用建筑和一般工業建筑的電氣工程電磁兼容的設計、施工、檢測及驗收。

MT 5010-1995煤礦安裝工程質量檢驗評定標準

本標準適用于煤礦礦井及選煤廠的工業設備、鋼結構井架、井筒裝備、工作壓力小于和等于10MPa的工業管道、小于和等于110kV的電氣裝置、通信、集控和架空索道等安裝工程的質量檢驗評定。本標準主要是根據頒發的有關技術標準和施工驗收規范并參照行業有關規范、標準等編制的。本標準未包括的工程項目及設備,建設單位可組織設計、施工單位按照本標準的制定原則,根據設計文件及設備出廠技術文件的要求自行補充臨時標準,經省、市、自治區煤炭主管部門批準后執行,并報煤炭工業部備案。

SL 531-2012大壩安全監測儀器安裝標準

本標準適用于各級水庫大壩嫉測儀器安裝與管理。20Om以上或特別重要大壩的安全監測儀器安裝應進行專門研究。

JG/T 439-2014家居配線箱

本標準規定了家居配線箱的術語、分類和標記、一般規定、要求、試驗方法、檢驗規則、標志、包裝、運輸和貯存。本標準適用于住宅套(戶)內的家居配線箱。

YD/T 2341.1-2011現場組裝式光纖活動連接器.第1部分：機械型

本部分規定了機械型現場組裝式光纖活動連接器（又稱機械型光纖快速連接器，以下簡稱機械型現場連接器）的要求、測量和試驗、質量評定程序、檢驗規則、標志、包裝、運輸及貯存。本部分適用于機械型現場組裝式光纖活動連接器。

YD/T 2341.2-2011現場組裝式光纖活動連接器.第2部分：熱熔型

本部分規定了熱熔型現場組裝式光纖活動連接器（又稱熱熔型光纖快速連接器，以下簡稱熱熔型現場連接器）的要求、測量和試驗、質量評定程序、檢驗規則、標志、包裝、運輸和貯存。本部分適用于熱熔型現場連接器。

EN ISO 13628-5-2009石油和天然氣工業.水下采油系統的設計和操作.第5部分:海底纜線

This International Standard specifies the general, and some of the special, requirements on materials used for the construction of equipment used in gas welding, cutting and allied processes.

BS EN ISO 13628-5-2009石油和天然氣工業.水下采油系統設計和操作.水下臍帶管

This part of ISO 13628 specifies requirements and gives recommendations for the design, material selection, manufacture, design verification, testing, installation and operation of umbilicals and associated ancillary equipment for the petroleum and natural gas industries. Ancillary equipment does not include topside hardware. Topside hardware refers to any hardware that is not permanently attached to the umbilical, above the topside hang-off termination.This part of ISO 13628 applies to umbilicals containing components, such as electrical cables, optical fibres, thermoplastic hoses and metallic tubes, either alone or in combination.This part of ISO 13628 applies to umbilicals for static or dynamic service, with surface-surface, surfacesubsea and subsea-subsea routings.This part of ISO 13628 does not apply to the associated component connectors, unless they affect the performance of the umbilical or that of its ancillary equipment.This part of ISO 13628 applies only to tubes with the following dimensions: wall thickness, t < 6 mm, internal diameter, ID < 50,8 mm (2 in). Tubular products greater than these dimensions can be regarded as pipe/linepipe and it is expected that they be designed and manufactured according to a recognised pipeline/linepipe standard.This part of ISO 13628 does not apply to a tube or hose rated lower than 7 MPa (1 015 psi).This part of ISO 13628 does not apply to electric cable voltage ratings above standard rated voltagesU0/U(Um) = 3,6/6(7,2) kV rms, where U0, U and Um are as defined in IEC 60502-1 and IEC 60502-2.